How shielding in an old home works

Hello:
I just did an energy audit on a home and tried to have a wireless set-up and the home was imposible to propagate the wireless wave.
I studied the home for three week and did computer analysis of the four panel in the home and came to a vivid conclusion.
The home has lead paint from the 1930's and the foundation is done with clay bricks that have certain mineral used in faraday cage to shieled from theEMf's in radio tower today.
I realized that this old structure was shielded from EMF's and also prvented the EMF's from leaving the home also.
I was confronted with a delema, the home was a good shield from the outside, but terrible inside if you have equipment that generate EMF's as this will not leave the home once inside, be absorbed by humans.
The solution for the home was to eliminate as much EMF producers and then take advantage of the naturally built faraday cage.
I am hard wiring the internet connection on the outside of the home, not inside in the attic, and installing EMF reducer, and harmonic compensaters that we sell.    
The other thing I plan to do is install a grounding grid around the home asthis will secure all static electricity and lightning protection.
This will allow the home to be invisible and become part of the earth or aswe call earthing the home.
This is part of new technology not normally used or understood.
I hope this is good info for those who want to do wireless in old homes, this is a no, no. Do the internet hard wire and if you can run the wires onthe outside then come in at the point of need, this will eliminate any insdie EMF's.
Here is a good link for those who would like to know about thing interfere with wireless.

http://www.far-far-away.com/~yousif/articles/wifi-sig.php

lazaro
later
See you in the light!

lazaro wrote:
> The home has lead paint from the 1930's and the foundation is done with clay bricks that have certain mineral used in faraday cage to shieled from the EMf's in radio tower today.
> I realized that this old structure was shielded from EMF's and also prvented the EMF's from leaving the home also.
>

It is not only older homes that can Amplify or Trap EMF inside. Metal
roofs are popular, but bounce everything inside back down at the occupants.

Also older insulation can have aluminum foil backing attached to the
kraft paper. This product has been discontinued because people want to
"get a signal" from outside.

One kind of insulation that is still available, is called R-Max, or
Poly-iso. The aluminum foil attached to the sheets of foam does work
good at trapping heat inside, and is marketed as such.

The only openings that remain, are the windows.


Taking this a step further, Is this metal box a good place for
electrosensitives? If we cover the windows, and paint the inside with
Y-shield absorber, would the inside be quiet?
I am wondering if this plan is missing anything. Is it the longitudinal
waves that keep coming in, or the likelyhood that other equipment inside
the house makes too much noise that gets reflected around like an oven?

Stewart

I think Stephen had mentioned earlier about people not feeling well when they are NOT connected to the earth's energies. (There was an extensive research experiment on this.) I would think that sealing one's home may be deleterious, because one is no longer getting any of the earth's energy fieldsmoving through... Debra Lynn Dadd advises against too much dennyfoil...

?

-Sue

--- In [hidden email], S Andreason <sandreas41@...> wrote:

Hi, Lolahunt3
I agree that the person in a home like this should have earth energy to drain, and balance the chakras system of the body.
There are several ways I have seen done to bring a good amount of energy into the home that is beneficial.
I have seen install in a home Rattan flooring which really help earth someone and organics in the floor and also organics in the woodworks maid of material that has good energy.
I have several ways I deal with the balance of energies; I use Mylar film (what is used in sailboat to absorb static energy. I used polymer plastics of different type that I test to see if the plastics absorb and release good energy. I usually use bubble wrap, certain potato bags, certain tea bags wrappers (especially organic green tea from bigallo), this might seem strange but I made a wand type of device that really works good and helps release negative energy from the body.
Later
Lazaro
See you in the light!

--- In [hidden email], "lolahunt3" <marydelamer@...> wrote:
>
> I think Stephen had mentioned earlier about people not feeling well when they are NOT connected to the earth's energies. (There was an extensive research experiment on this.) I would think that sealing one's home may be deleterious, because one is no longer getting any of the earth's energy fields moving through... Debra Lynn Dadd advises against too much dennyfoil...
>

I live in a well shielded house. It is an aluminun sided mobile home with two metal roofs. The aluminum is probably good to reflect emf away from the outside of the house. But you don't want to live in an aluminum sided house without something on the inside to shield you also as the aluminum reflects inward as well as outward the signals that bounce off of it from the outside. There was a study done at Harvard I've read on the web about this. They even went so far as to suggest that it was the government who may have promoted the whole tinfoil hat thing for that reason. So you want a cage within a cage which is what a true faraday cage is. And so I have much blocking material on the inside walls as well. I myself do not care for the energy that comes up from the earth. And I've been doing some tiling of the floor which gives a really good effect. I used to ground my mobile home but I don't anymore.

[Non-text portions of this message have been removed]