Posted by NoRadiationForYou on
URL: https://www.es-forum.com/Suddenly-emf-sensitive-tp4036412p4036421.html

Thanks for posting this story.
Sharing this helped me understand this new field of HNT, which I was not aware of.

Regarding high reading, while the light in this room is on,  it could be because of bad electricity connectivity or high EMF lights, but it could be another reason as well.  Usually, light bulbs are not high current and therefore are not high EMF sources, unless you are right next to them, or they are using lots of CFL light bulbs, or in some wired configuration.  

The Smart meter is a high EMF source. It (and electric cabinets switch box) emits high ELF magnetic and electric fields. In addition, the smartest meters emit very high RF pulses every 3-15 seconds. Lots of people got sick because of them. Very close to them you would measure both ELF and RF. few meters away from them you will measure mostly RF (the ELF fields drop, the RF still exist).
Please see - https://www.norad4u.com/knowledge/smart-radiating-meters/

6mG is far from OK. OK should be lower than 2 mG, even lower for EHS people.

As for RF, I think that for EHS people the level should be below 0.001mW/m2. but the TF2 is measuring also frequencies below 100MHz and has the habit of showing very high levels, so I am not sure what this means. it mixes things up.
If you see 1.889mW/m2 on the TF2, then the levels are high.
I usually look at the peaks, not the average.

If the room is bad, and you feel bad, and you already stopped using RF emitting devices, and the levels are high, If I was in your place, I would move.

From what you are writing, it seems that you are just on the start of learning about EMF and EHS. In this point of time it might be too much to expect that you would be able to do the protection nad measurement the right way, so the best option would be to find a place with ELF magnetic field lower than 1mG and RF lower than 0.001mW/m2.