Posted by charles on
URL: https://www.es-forum.com/DIY-alternative-3-in-1-low-EMF-computer-Mouse-Keyboard-Microphone-tp4030078p4030219.html

In my opinion, one should first eliminate all possible elektrosmog components.
They are in the frequency range of 5kHz and 10MHz.
You can find them with a HAM radio or de Esmog Spion.

There are monitors and monitors.
I had an Acer 24", which gave big peaks at 47.5MHz.
Now I have a Philips27", no problems.

I had a mouse on a PS2 plug. A lot of elektrosmog.
Now I use one with USB.
The cablke should be *not shielded*.

I had a Microsoft 600 wired keyboard. That one died.
I got one Trust keybord. When I went with my detector over it, saomething peculiar happened.
Right over the keyboard, I measured strong fields. When I went upwards, the fields went down, but whrn I got again upwards, the fields get stronger, etc..
Now I am using e Microsoft 600 keyboard again, and nu trouble.
The wiring should be *not shielded*.

The cables are treated with this alu film. Pagina600.html
The keyboard as well as the monitor do have these Gebbensleben stickers.

When you are using a shielded keyboard or mouse, the dirtyyu frequencies are trapped inside the cables, and cannot escape, so they escape under your hand.

One of the worst elektrosmog causers is the power transformer in the computer.
I got a new desktop computer, but with a very bad power transformer.
I let them exchange for another one, and the problems are gone.