Posted by S Andreason on
URL: https://www.es-forum.com/Introduction-tp4023749p4023802.html

Hi Lizzie,

> So what you're saying is, metal roof and walls as long as the floor is not metal,shields?
Yes, I meant the floor doesn't need to be covered in metal if it is on
the ground, meaning 1st floor, ground level. Earth.


> While cars, buses, trains, and planes.... because they are ALL metal chassis framed, become radiation cageswhen a cell phone is used in the car.
>  
Yes. And there are pictures out there showing how the inside of a car is
a hot zone when a cell phone is in use.


>  How can the floor count as a ground? What if the ceiling under neath the flooring, has over head lighting?
Then it is not ground. Just a 2nd story floor or more.
When there are lighting ballasts in the floor, then you're standing
closer to the magnetic field than the occupants one floor below are to
their head.

Back in 1993 when I was starting to get sick, I tried resting upstairs
in the accountant's vacant office. Boy did I get worse! I could kick
myself for that, as I was laying down On the florescent ballast below.
I figured it out within a couple days too.


> Then its only safe when the main power box is turned off?
How about "safer" and "safest," yes.
Need to stop the 120V AC wires from emitting a electric field, and to
stop any dirty electricity from coming into your house.


>  What if the ground floor, happens to be in an area where there is a lot of stray voltage running thru the earth?
Oh, if you only knew how much that has been on my mind lately....
The ground floor here is concrete, with rebar and wire mesh for strength.
For a few years now, I have been measuring an electric field, comparing
it to ground, in the wall outlet.
Just last week, I had some discovery and ah ha moments, when I found the
outlet ground differs from the outside earth ground. Even with several
grounding rods tied in across several "buildings", there is 2 to 3 volts
AC, and 0.28 Amps AC. Got a Gigahertz Solutions ELF meter for magnetic
and electric fields, and it measured 50-90 V/m. No wonder I have been
getting worse the last 2 years or more. I ran a new grounding cord to a
new grounding rod for my bed enclosure, and now the bed matches earth
ground. Now I can sleep in a clean 0 V/m box. No jokes about dying please.
Now time will tell how I heal.

Yes, when the county wide storm emergency and power outage occurred in
July, out for several days, the outlet ground matched earth ground. I
measured it every time the PUD connected a major transmission or
distribution line. It is clearly connected with the big line (a mile
away) running up the valley to Curlew, and not any small lines in the
valley here. Problem is I don't know what to do about it now. Is this
the PUD's problem? and how to convince them of that...


>  instead of the current returning to the sub stations,it takes the path of least resistance, thru the ground, any water pipes, metal gas lines,
Don't have any metal pipes here. Just rocks.

Stewart
http://seahorseCorral.org