> Is Cindy Sage saying the heating from the RF of dirty electricity is going
> to cause house fires?  That strikes me as absurd.  Yes the 3rd harmonic
> (180 Hz) can be a problem for motors and such, and the higher harmonics
> just contribute more, but the joule heating from the RF is insignificant
> unless you have a serious broadcasting set up.  At 1 MHz or so it can go
> quite far on wiring, but by the time you get to 2.4 GHz, no.    There's too
> much inductance (which is proportional to loop area times frequency).  I've
> never noticed microwave readings being higher near wiring, but the AM radio
> will sure buzz...
>
>
> On Fri, Dec 2, 2011 at 9:31 AM, Elizabeth thode <[hidden email]>wrote:
>
>>
>> Yes folks. This is true.
>> Lizzie
>> Commentary by Cindy Sage, Sage Associates and James J. Biergiel, EMF
>> Electrical Consultant July 2010
>>
>> Typical gauge electrical wiring that provides electricity to buildings
>> (60 Hz power) is not constructed or intended to carry high frequency
>> harmonics that are increasingly present on normal electrical wiring.  The
>> exponential increase in use of appliances, variable speed motors, office
>> and computer equipment and wireless technologies has greatly increased
>> these harmonics in community electrical grids and the buildings they serve
>> with electricity.  Harmonics are higher frequencies than 60 Hz that carry
>> more energy, and ride along on the electrical wiring in bursts.   Radio
>> frequency (RF) is an unintentional by-product on this electrical wiring
>> Electrical wiring it is not sized for the amount of energy that radio
>> frequency and microwave radiation.  These unintended signals that can come
>> from new wireless sources of many kinds are particularly a worry for the
>> new smart meters that produce very high intensity radio frequency energy in
>> short bursts.  Electrical fires are likely to be a potential problem.
>> Electrical wiring was never intended to carry this – what amounts to an
>> RF pollutant – on the wiring.  The higher the frequency, the greater the
>> energy contained.  It’s not the voltage, but it is the current that
>> matters.  RF harmonics on electrical systems can come from computers,
>> printers, FAX machines, electronic ballasts and other sources like variable
>> speed motors and appliances that distort the normal, smooth 60 hertz sine
>> wave of electrical power and put bursts of higher energy RF onto the wiring.
>> Wireless smart meters don’t intentionally use the electrical system to
>> send their RF signal back to the utility (to report energy usage, etc).
>> But, when the wireless signal is produced in the meter… it boomerangs
>> around on all the conductive components and can be coupled onto the wiring,
>> water and gas lines, etc. where it can be carried to other parts of the
>> residence or building.
>> It is an over-current condition on the wiring.  It produces heat where
>> the neutral cannot properly handle it. The location of the fire does NOT
>> have to be in close proximity to the main electrical panel where the smart
>> meter is installed.
>>
>>
>>
>> To: [hidden email]
>> From: [hidden email]
>> Date: Fri, 2 Dec 2011 12:31:51 +0000
>> Subject: [eSens] Re: Basement Homes?
>>
>>
>>
>>
>>
>>
>> I do think that broadband is travelling on the wires. Maybe it is
>> induction as the cable wires are right next to the power line wires.
>> Telephone wires too.
>>
>> K
>> - In [hidden email], Bill Bruno <wbruno@...> wrote:
>> >
>> > Wi-Fi won't go very far on wiring (probably a few inches, though it
>> > could travel further in shielded wiring). Although the same pulse
>> > structure might appear in the dirtly electricity do to power supply
>> loads
>> > pulsing with the microwaves.
>> >
>> > On Thu, Dec 1, 2011 at 10:37 AM, KathyB <calicocat477@...> wrote:
>> >
>> > > **
>> > >
>> > >
>> > > Loni,
>> > >
>> > > I think a basement would help IF one does not have underground wiring
>> &
>> > > radon & mold free. .
>> > >
>> > > We have one, it helps but I feel the underground wiring & have to have
>> > > safer wiring that will run above your head. There will be wire free
>> ceiling
>> > > places you can locate.
>> > >
>> > > I tested
>> > > w my cheaper meter at 1 Gauss on the floor. I'm pretty sure wi-fi is
>> on
>> > > our wring.
>> > > I read .06 mw/m 2 RF at an outlet. We have from ..01 - .03 in our free
>> > > space *& live in a valley.
>> > >
>> > > Kathy
>> > >
>> > > From: Loni <loni326@...>
>> > > Subject: [eSens] Basement Homes?
>> > > To: [hidden email]
>> > > Date: Thursday, December 1, 2011, 11:28 AM
>> > >
>> > >
>> > >
>> > >
>> > >
>> > >
>> > > Do you think a basement home would sheild some of the Cell radiation?
>> > > Anyone have one that can advise?
>> > >
>> > >
>> > >
>> > > Does the cell antenna's rf ride in on your elecrtrical wires in your
>> home?
>> > >
>> > >
>> > >
>> > > Thanks, Loni
>> > >
>> > > [Non-text portions of this message have been removed]
>> > >
>> > > [Non-text portions of this message have been removed]
>> > >
>> > >
>> > >
>> >
>> >
>> > [Non-text portions of this message have been removed]
>> >
>>
>>
>>
>>
>>
>>
>> [Non-text portions of this message have been removed]
>>
>>
>>
>> ------------------------------------
>>
>> Yahoo! Groups Links
>>
>>
>>
>>
>